These are standard specifications for the 1976 Ford Bronco, not necessarily specifications for the vehicle(s) in the photo(s).
Transmission:
Manual , 3 Automatic
Chassis # U15GLA81612
Auction entries : 1
Chassis # U15GLA81614
Chassis # U15GLS82993
View info And history
Auction entries : 1
Chassis # U15GLA58968
View info And history
Auction entries : 2
Chassis # U15GLC30583
View info And history
Information provided by NHTSA
Data updated January 2023
Features
| Engine Location : | Front |
| Drive Type : | 4WD |
| Body / Chassis : | Ladder frame |
| Production Years for Series : | 1966 - 1977 |
| Price : | $2,194 |
Engine & Transmission
| V 8 90-degree | |
|---|---|
| Displacement : | 4949 cc | 302.0 cu in. | 5.0 L. |
| Power : | 138 BHP (101.568 KW) @ 3600 RPM |
| Torque : | 245 Ft-Lbs (332 NM) @ 2000 RPM |
| Bore : | 4.0 in | 102 mm. |
| Stroke : | 3.0 in | 76 mm. |
| Compression : | 8.0:1 |
| Main Bearings : | 5 |
| Construction : | Cast-iron block and head |
| Ford carburetor | |
Manual , 3 Automatic
Production Figures
| Total Ford Production for 1976 : | 1,861,537 |
| 1976 Ford Bronco | |
Dimension(s)
SUV
Chassis # U15GLA81612
Auction entries : 1
Chassis # U15GLA81614
Chassis # U15GLS82993
View info And history
Auction entries : 1
Chassis # U15GLA58968
View info And history
Auction entries : 2
Chassis # U15GLC30583
View info And history
| Seating Capacity : | 4 |
| Doors : | 2 |
| Exterior | |
|---|---|
| Width : | 79.3 in | 2014 mm. |
| Height : | 75.5 in | 1918 mm. |
| Wheelbase : | 92.0 in | 2337 mm. |
Handling
| Suspension | |
|---|---|
| Mono-Beam front suspension with lockable four-wheel drive and double-acting shock absorbers | |
| Steering | |
|---|---|
| Turning Circle : | 34.0 ft |
| Brakes | |
|---|---|
| Front Brakes : | Disc |
| Rear Brakes : | Drum |
Recall
| Component | FUEL SYSTEM, GASOLINE:DELIVERY:FUEL PUMP |
|---|---|
| Manufacturer | FEDERAL-MOGUL CORPORATION |
| NHTSA Campaign ID | 07E064000 |
| Summary | CERTAIN FEDERAL-MOGUL AFTERMARKET FUEL PUMPS SOLD UNDER THE BRAND NAMES OF CARTER, ACCUFLOW, NAPA, TRUFLOW, PARTS DEPO, AND PARTS MASTER, SHIPPED BETWEEN AUGUST 2006 AND JULY 2007 FOR USE ON THE VEHICLES LISTED ABOVE. THE FUEL PUMP DIAPHRAGM IN CERTAIN PRODUCTION RUNS MAY HAVE BEEN IMPROPERLY INSTALLED OR INADEQUATELY TESTED WHICH MAY CAUSE THE FUEL PUMP TO LEAK. |
| Consequence | A LEAKING FUEL PUMP COULD CREATE A VEHICLE FIRE HAZARD. |
| Remedy | FEDERAL-MOGUL WILL NOTIFY OWNERS AND REPLACE THE DEFECTIVE FUEL PUMPS FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 15, 2007. OWNERS CAN CONTACT FEDERAL-MOGUL AT 248-354-7700. |
| Notes | THIS RECALL ONLY PERTAINS TO AFTERMARKET CARTER, NAPA, ACCUFLOW, TRU FLOW, PARTS MASTER, AND PARTS DEPOT BRAND FUEL PUMPS AND HAS NO RELATION TO ANY ORIGINAL EQUIPMENT INSTALLED ON THE LISTED MOTOR VEHICLES.CUSTOMERS MAY CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S VEHICLE SAFETY HOTLINE AT 1-888-327-4236 (TTY: 1-800-424-9153); OR GO TO SAFERCAR.GOV. |
| Component | ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:MANIFOLD/HEADER/MUFFLER/TAIL PIPE |
|---|---|
| Manufacturer | FORD MOTOR COMPANY |
| NHTSA Campaign ID | 76V015000 |
| Notes | FORD CAMPAIGN NO 183.POSSIBILITY THAT THE EXHAUST SYSTEM MUFFLER THATINCORPORATES AN INTEGRAL, SOLID, CLOSED-END BRUSH SHIELD MAY EXPERIENCE MUFFLERFAILURE DUE TO EXCESSIVE HEAT BUILD-UP.THE TYPICAL LOCATION OF FAILURE INMUFFLER ALLOWS HIGH TEMPERATURE EXHAUST GASES TO BE DIRECTED AGAINST THE FLOORPAN IN SUCH A MANNER THAT COULD RESULT IN HEAT DAMAGE TO AN OPTIONAL AUXILIARYPOLYETHYLENE AUXILIARY FUEL TANK AND ADJACENT FUEL HOSE, WIRING HARNESS,AUXILIARY FUEL TANK HOSE AND FRONT INBOARD SEAT BELT ASSEMBLIES.IF THISCONDITION EXISTS AND THE INSULATION IS MISSING FROM THE WIRING HARNESS, ITCOULD PROVIDE A NEARBY SOURCE OF IGNITION SHOULD FUEL SPILLAGE OCCURS DUE TOTHERMAL DAMAGE TO AUXILIARY FUEL TANK.(CORRECT BY INPSECTING AND INSTALLINGMUFFLERS WHERE NECESSARY AND REPALCE OR REPAIR FUEL TANK, WIRING HARNESS ANDSEAT BELT COMPONENTS). |
Data updated January 2023
1976 Averages
| Avg. Car Cost : | $1 |
| Avg. Household Income : | $16,000 |
| Avg. Home : | $43,400 |
Popular frequently asked questions include:
What are the dimension and mechanical specifications of the 1976 Ford Bronco?
Q: What is the wheelbase size of the 1976 Ford Bronco? A: The 1976 Ford Bronco has a wheelbase size of 92.00 inches.Q: What is the width of the 1976 Ford Bronco? A: The 1976 Ford Bronco has a width of 79.30 inches.Q: How much did the 1976 Ford Bronco cost when new?A: The 1976 Ford Bronco had a base price of approximately $2,194 (USD).Q: What is the bodystyle of the 1976 Ford Bronco? A: The 1976 Ford Bronco was a SUV.Q: How many vehicles did Ford produce in 1976? A: Ford produced 1,861,537 automobiles in 1976.Q: What engine did the 1976 Ford Bronco have? A: The engine powering the 1976 Ford Bronco was a V 8 (4949 cc | 302.0 cu in. | 5.0 L.) with 138 BHP (101.568 KW) @ 3600 RPM and 245 Ft-Lbs (332 NM) @ 2000 RPM. Q: What transmissions did the 1976 Ford Bronco have? A: The 1976 Ford Bronco had the following gearbox options: Manual, 3 speed Automatic.