These are standard specifications for the 1969 Triumph GT6, not necessarily specifications for the vehicle(s) in the photo(s).
Transmission:
4 Manual
Information provided by NHTSA
Data updated January 2023
Features
Engine Location : | Front |
Drive Type : | Rear Wheel |
Body / Chassis : | Steel body on steel frame |
Production Years for Series : | 1968 - 1969 |
Body Designer : | Giovanni Michelotti |
Price : | $2,990 |
Weight : | 1790 lbs | 811.93 kg |
Engine & Transmission
Straight 6 | |
---|---|
Displacement : | 1998 cc | 121.9 cu in. | 2.0 L. |
Power : | 95 BHP (69.92 KW) @ 4700 RPM |
Torque : | 117 Ft-Lbs (159 NM) @ 3400 RPM |
Bore : | 2.9 in | 75 mm. |
Stroke : | 3.0 in | 76 mm. |
Compression : | 9.25:1 |
Main Bearings : | 4 |
Construction : | Cast-iron block and head |
Ignition system : | 2 Zenith Stromberg carbs |
4 Manual
Production Figures
Total Triumph Production for 1969 : | 17,112 |
GT6 MKII Production (1968-1969) : | 15,818 |
1969 Triumph GT6 |
Dimension(s)
Fastback Coupe
Body Designer : | Giovanni Michelotti |
Seating Capacity : | 2 |
Doors : | 2 |
Exterior | |
---|---|
Length : | 149.0 in | 3785 mm. |
Width : | 57.0 in | 1448 mm. |
Height : | 47.0 in | 1194 mm. |
Wheelbase : | 83.0 in | 2108 mm. |
Front Track : | 49.0 in | 1245 mm. |
Rear Track : | 49.0 in | 1245 mm. |
Handling
Suspension | |
---|---|
Front : Unequal-length A-arms with coil springs Rear : Double-jointed half-shafts with lower A-arms and transverse leaf springs |
Steering | |
---|---|
Rack and Pinion |
Recall
Component | FUEL SYSTEM, GASOLINE:STORAGE:TANK ASSEMBLY:FILLER PIPE AND CAP |
---|---|
Manufacturer | JAGUAR CARS |
NHTSA Campaign ID | 70V006000 |
Notes | POSSIBILITY OF IMPROPER ADHESION OF MAGNET TO GAS TANK FILLER CAP DUE TOCLEANING IMPERFECTIONS OF FILLER CAP AFTER MACHINING.IF THIS CONDITIONEXISTS, GASOLINE COULD SPILL WHEN STARTING OR STOPPING VEHICLE.(CORRECT BYINSPECTING AND REPLACING CAP WHEN NECESSARY.) |
Component | SUSPENSION:REAR:SPRINGS:LEAF SPRING ASSEMBLY:HANGER/BRACKET |
---|---|
Manufacturer | JAGUAR CARS |
NHTSA Campaign ID | 69V104000 |
Notes | POSSIBILITY OF FATIGUE FAILURE OF BODY PANEL IN AREA WHERE REAR SUSPENSIONRADIUS ARM BRACKET IS ATTACHED.(CORRECT BY INSTALLING FOUR HIGH TENSILE BOLTSINTO FLOOR PAN TO REINFORCE BRACKET.) THIS IS A SUP- PLEMENT RECALL TO CAMPAIGNNUM- BER 68-0105, OCTOBER 29, 1968. |
Component | TIRES:MARKINGS |
---|---|
Manufacturer | JAGUAR CARS |
NHTSA Campaign ID | 69V024000 |
Notes | POSSIBILITY THAT THE WORDS 'TUBED TYPE', WERE OMITTED FROM RE- QUIRED DATA TOBE SHOWN ON TIRE SIDE WALLS.NO SAFETY HAZARD IS IN- VOLVED.(CORRECT BYAPPLYING SELF- VULCANIZING ADHESIVE IMPRINTS OF DATA TO BOTH SIDE WALLS.) |
Component | SEAT BELTS:FRONT:ANCHORAGE |
---|---|
Manufacturer | JAGUAR CARS |
NHTSA Campaign ID | 71V072000 |
Notes | TRIUMPH SERVICE BULLETIN NO 71-C-8.POSSIBILITY THAT LAP-TYPESEATBELTINSTEAD OF SHOULDER-TYPE SEATBELT WAS INSTALLED IN V EHICLE.(CORRECT BYREPLACING WITH PROPER BELT.) |
Component | SEATS |
---|---|
Manufacturer | JAGUAR CARS |
NHTSA Campaign ID | 69V113000 |
Notes | POSSIBILITY THAT IMPROPER USE OF SEAT SLIDE OPERATING LEVER WILL CAUSE IT TOBREAK.IF THIS CONDITION EXISTS SEAT WOULD NOT BE SECURED PROPERLY ON SEATSLIDES.(CORRECT BY REPLACING BROKEN LEVER WHERE NECESSARY, AND INSTRUCTINGIN PROPER USE.) |
Component | SEAT BELTS:FRONT:ANCHORAGE |
---|---|
Manufacturer | JAGUAR CARS |
Mfr Report Date | 19680101 |
NHTSA Campaign ID | 71V196000 |
Notes | UNDER TESTING, SEAT BELTS SUPPLIED BY U.S.SAFETY WEAVE COM PANY FAILED TOMEET LOAD REQUIREMENTS OF FEDERAL MOTOR VEHICLESAFETY STANDARD NO.209.(CORRECT BY INSPECTING AND REPLACI NG WHERE NECESSARY.) |
Component | EXTERIOR LIGHTING:HEADLIGHTS:SWITCH |
---|---|
Manufacturer | JAGUAR CARS |
Mfr Report Date | 19680901 |
NHTSA Campaign ID | 78V013000 |
Summary | THE HEADLAMP SWITCHES MAY MALFUNCTION ON THE INVOLVED VEHICLES. SHOULD THIS OCCUR, LOSS OF HEADLAMP AND TAILLAMP ILLUMINATION MAY RESULT. SWITCH BREAKAGE WILL ONLY OCCUR WHEN THE SWITCH IS BEING TURNED ON OR OFF. |
Remedy | DEALER WILL REPLACE THE DEFECTIVE SWITCH AT NO CHARGE. |
Notes | VEHICLE DESCRIPTION: PASSENGER VEHICLES.SYSTEM: LIGHTING AND COMMUNICATIONS; MASTER HEADLAMP SWITCH.CONSEQUENCES OF DEFECT: HEADLIGHT AND TAILLIGHT FAILURE, DURING NIGHTTIME ORPOOR WEATHER CONDITIONS, COULD LEAD TO A VEHICLE ACCIDENT. |
Data updated January 2023
1969 Averages
Avg. Car Cost : | $3,270 |
Avg. Household Income : | $9,302 |
Avg. Home : | $15,500 |
Avg. Gallon of Gas : | $0.35 |
Popular frequently asked questions include:
What are the dimension and mechanical specifications of the 1969 Triumph GT6?
Q: What is the wheelbase size of the 1969 Triumph GT6? A: The 1969 Triumph GT6 has a wheelbase size of 83.00 inches.Q: What is the length of the 1969 Triumph GT6? A: The 1969 Triumph GT6 has a length of 149.00 inches.Q: What is the width of the 1969 Triumph GT6? A: The 1969 Triumph GT6 has a width of 57.00 inches.Q: How much did the 1969 Triumph GT6 cost when new?A: The 1969 Triumph GT6 had a base price of approximately $2,990 (USD).Q: What is the bodystyle of the 1969 Triumph GT6? A: The 1969 Triumph GT6 was a Fastback Coupe.Q: How many vehicles did Triumph produce in 1969? A: Triumph produced 17,112 automobiles in 1969.Q: How many GT6 MKII were produced? A: Triumph produced 15,818 examples of the GT6 MKII from 1968 to 1969.Q: What engine did the 1969 Triumph GT6 have? A: The engine powering the 1969 Triumph GT6 was a Straight 6 (1998 cc | 121.9 cu in. | 2.0 L.) with 95 BHP (69.92 KW) @ 4700 RPM and 117 Ft-Lbs (159 NM) @ 3400 RPM. Q: What transmission did the 1969 Triumph GT6 have? A: The 1969 Triumph GT6 had a 4 speed Manual gearbox.
What are the dimension and mechanical specifications of the 1969 Triumph GT6?
How many 1969 Triumph GT6 were produced?
How powerful was the 1969 Triumph GT6? Was the 1969 Triumph GT6 popular? Was the 1969 Triumph GT6 expensive? What was the fuel economy of the 1969 Triumph GT6?
Q: What is the wheelbase size of the 1969 Triumph GT6? A: The 1969 Triumph GT6 has a wheelbase size of 83.00 inches.Q: What is the length of the 1969 Triumph GT6? A: The 1969 Triumph GT6 has a length of 149.00 inches.Q: What is the width of the 1969 Triumph GT6? A: The 1969 Triumph GT6 has a width of 57.00 inches.Q: How much did the 1969 Triumph GT6 cost when new?A: The 1969 Triumph GT6 had a base price of approximately $2,990 (USD).Q: What is the bodystyle of the 1969 Triumph GT6? A: The 1969 Triumph GT6 was a Fastback Coupe.Q: How many vehicles did Triumph produce in 1969? A: Triumph produced 17,112 automobiles in 1969.Q: How many GT6 MKII were produced? A: Triumph produced 15,818 examples of the GT6 MKII from 1968 to 1969.Q: What engine did the 1969 Triumph GT6 have? A: The engine powering the 1969 Triumph GT6 was a Straight 6 (1998 cc | 121.9 cu in. | 2.0 L.) with 95 BHP (69.92 KW) @ 4700 RPM and 117 Ft-Lbs (159 NM) @ 3400 RPM. Q: What transmission did the 1969 Triumph GT6 have? A: The 1969 Triumph GT6 had a 4 speed Manual gearbox. Similar Automakers
Similarly Sized Vehicles
from 1969
Similarly Priced Vehicles
AMC Rambler Hurst S/C ($2,995-$2,995)
Chevrolet Chevelle ($2,485-$3,270)
Oldsmobile Cutlass ($2,685-$3,155)
BMW 2002 ($2,980-$2,980)
Plymouth Satellite ($2,636-$3,349)
Plymouth Barracuda ($2,675-$3,085)
Mercury Cougar ($3,000-$3,575)
Plymouth Fury ($2,700-$3,715)
Chevrolet Impala ($2,910-$3,465)
Mercury Montego ($2,540-$2,980)
Average Auction Sale: $37,821
Chevrolet Chevelle ($2,485-$3,270)
Oldsmobile Cutlass ($2,685-$3,155)
BMW 2002 ($2,980-$2,980)
Plymouth Satellite ($2,636-$3,349)
Plymouth Barracuda ($2,675-$3,085)
Mercury Cougar ($3,000-$3,575)
Plymouth Fury ($2,700-$3,715)
Chevrolet Impala ($2,910-$3,465)
Mercury Montego ($2,540-$2,980)
Average Auction Sale: $37,821