Maserati 200 Si
Total Production: 32 1955 - 1958
Maserati's aging but still impressive A6GCS needed improvement in order to remain competitive. The decision was made to address the 4C2F engine that had been in production since the early 1950s and used in Formula 2 racing. Development began and the project was codenamed 'Tipo 52', but commonly referred to as Tipo 200S. In order to speed up production and reduce costs, the project was divided into two groups, the 150S and the 200S. The 2-liter 200S engines were similar to the 150S, both had five main bearings, dual overhead camshafts, dual ignition with magnetos, and dual Weber 50 DC03 carburetors. The carburetors were quickly replaced with a 45 DCO3s unit. A four-speed gearbox was installed but later removed in favor of a five-speed all-synchromesh transmission driven through a limited-slip differential. Top speed could be achieved at just over 160 mph. Due to improvements, modifications, and enhancements, specifications vary.
The DeDion Type rigid rear axle was courtesy of the A6GCS. The suspension was comprised of independent coil springs, torsion bar and shock absorbers in the front and transverse leaf springs and shock absorbers in the rear. The chassis was nearly identical to the one used for the 150S. Braking power was from hydraulic brakes fitted on all four wheels and cooled by centrifugal air. The fuel tank had a 22-gallon capacity.
A 200S was entered into the 1955 Imola Grand Prix and driven by Franco Bordoni where it left with disappointing results. Further work was needed to make it competitive. Later in the season, a pair of 200S was entered into the Targa Florio. At the checkered flag it was a Maserati in the lead, but not the 200S. An A6GCS driven by Francesco Giardini managed to secure the overall victory while the two 200S were both forced to retire prematurely due to mechanical difficulties.
The 200S's two biggest flaws were its handling and its braking. These were addressed on the off-season and the vehicles were prepared for 1956. All three 200S's, chassis number 2403, 2404, and 2405, were entered in the Supercortemaggiore GP. 2403 and 2404 borrowed the chassis design from the 150S and had a DeDion bridge anchored to the differential with a sliding pin. 2405 had a traditional rigid rear axle. The bodies differed slightly in an effort to capitalize on aerodynamic features. One of the 200S's was damaged during practice and a second 200S retired after the first lap. Chassis number 2405 showed potential and finished the race, but did not achieve the success Maserati was hoping for. Nevertheless, the decision was made to continue with production. A tubular chassis was selected and the coachwork was passed from Celestino Fiandri to Medardo Fantuzzi.
Further development and modifications brought about the 200SI, meaning Sport Internazionale, indicating their compliance with newly adopted regulations. These regulations stated that the cars needed to comply with new rules and specifications in order to compete in international racing. The changes included a soft-top, full windshield with wipers and doors. The dimensions and specifications of many of the mechanical components were also dictated within these rules.
Replacing the successful A6GCS was a tall order which the 200S had done rather well. Like most other vehicles, it suffered from teething problems with many of its issues being ironed out with continued development. It required a skilled driver to control, especially at high speeds. Nevertheless, it is one of Maserati's most successful smaller-displacement racing cars. They were customer race cars that were quick, powerful, and durable. Their most prestigious victories were class wins at the 1956 Mille Miglia and the 1957 European Mountain Championship.
Later, the engines were enlarged and the 200S became the 250S. There were only four created by Maserati, while many of the privateers made the same modifications.
By Daniel Vaughan | Sep 2019