1990 Mitsubishi Eclipse Specifications

These are standard specifications for the 1990 Mitsubishi Eclipse, not necessarily specifications for the vehicle(s) in the photo(s).

Features

Engine Location :	Front
Drive Type :	Front Wheel
Body / Chassis :	Steel unibody
Production Years for Series :	1990 - 1994
MPG City :	20
MPG Highway :	25

Performance

0-60 mph :	7 seconds.
1/4 Mile :	15.3 seconds.

Engine & Transmission

Inline 4
Displacement :	1775 cc \| 108.3 cu in. \| 1.8 L.
Power :	92 BHP (67.712 KW) @ 5500 RPM
Torque :	105 Ft-Lbs (142 NM) @ 3500 RPM
Bore :	3.2 in \| 81 mm.
Stroke :	3.5 in \| 90 mm.
Compression :	9.0:1
Valvetrain :	8 OHC (2 valves per cylinder)
Cylinder Block :	Cast-iron
Cylinder Head :	Light Alloy
Multi-point Electronic Fuel Injection

Transmission:
5 Manual , 4 Automatic

Production Figures

Total Mitsubishi Production for 1990 :	99,630
1990 Mitsubishi Eclipse

Handling

Recall

Component	EXTERIOR LIGHTING
Manufacturer	SABERSPORT
NHTSA Campaign ID	09E012000
Summary	SABERSPORT IS RECALLING 16,270 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, 'LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.' THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.
Consequence	DECREASED LIGHTING VISIBILITY MAY RESULT IN A VEHICLE CRASH.
Remedy	SABERSPORT WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON MAY 11, 2009. OWNERS MAY CONTACT SABERSPORT AT 1-909-598-7589.
Notes	THIS RECALL ONLY PERTAINS TO AFTERMARKET REPLACEMENT EQUIPMENT AND HAS NO RELATION TO ANY ORIGINAL EQUIPMENT INSTALLED ON VEHICLES PRODUCED BY THE VEHICLE MANUFACTURER.IN ORDER TO DETERMINE IF YOUR AFTERMARKET LAMP ASSEMBLY IS AFFECTED BY THIS NONCOMPLIANCE, PLEASE REVIEW THE LIST OF MODEL NUMBERS PROVIDED TO US BY SABERSPORT.THE LIST CAN BE FOUND UNDER 'DOCUMENT SEARCH' LOCATED AT THE BOTTOM OF YOUR SCREEN.OWNERS MAY ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S VEHICLE SAFETY HOTLINE AT 1-888-327-4236 (TTY 1-800-424-9153), OR GO TO

Component	EXTERIOR LIGHTING
Manufacturer	AJ MOTORSPORT
NHTSA Campaign ID	06E065000
Summary	CERTAIN AJ MOTORSPORT COMBINATION LAMPS SOLD AS REPLACEMENT LAMPS FOR USE ON THE ABOVE LISTED PASSENGER VEHICLES. COMBINATION LAMPS NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.
Consequence	LACK OF AMBER SIDE REFLECTORS IN THE LAMPS WILL DECREASE LIGHTING VISIBILITY TO OTHER DRIVERS AND MAY POSSIBLY RESULT IN A VEHICLE CRASH.
Remedy	AJ MOTORSPORT WILL NOTIFY OWNERS AND OFFER REIMBURSEMENT FOR THE LAMPS. THE RECALL BEGAN ON JULY 31, 2006. OWNERS MAY CONTACT AJ MOTORSPORT AT 626-618-2026.
Notes	THIS RECALL ONLY PERTAINS TO AJ MOTORSPORT AFTERMARKET LAMPS AND HAS NO RELATION TO ANY ORIGINAL EQUIPMENT INSTALLED ON THE LISTED PASSENGER VEHICLES.FOR MORE INFORMATION ON THE LAMP MODEL NUMBERS, CLICK ON DOCUMENT SEARCH AND VIEW DOCUMENT TITLED 'LAMP MODEL NUMBERS.'CUSTOMERS MAY CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S VEHICLE SAFETY HOTLINE AT 1-888-327-4236 (TTY: 1-800-424-9153); OR GO TO SAFERCAR.GOV.

Component	SEAT BELTS:FRONT:BUCKLE ASSEMBLY
Manufacturer	MITSUBISHI AMERICA
Mfr Report Date	19860101
NHTSA Campaign ID	95V103004
Summary	THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED 'PRESS.' IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY.
Consequence	THE SAFETY BELTS WOULD NOT PROVIDE ADEQUATE PROTECTION TO AN OCCUPANT IN A VEHICLE CRASH.
Remedy	OWNERS SHOULD PROMPTLY CHECK THE CONDITION AND OPERATION OF BOTH FRONT SAFETY BELT BUCKLES AND CAREFULLY INSPECT THE RED RELEASE BUTTON FOR ANY BREAKS OR CRACKS. THEY SHOULD ENSURE THAT BOTH BUCKLES ARE OPERATING PROPERLY BY INSERTING EACH LATCH PLATE INTO ITS BUCKLE, TUGGING ON THE BELT TO MAKE SURE THE LATCH IS SECURELY LOCKED, AND THEN PRESSING THE RELEASE BUTTON. THE LATCH PLATE SHOULD POP OUT OF THE BUCKLE WHEN THE BUTTON IS PRESSED. IF EITHER RELEASE BUTTON SHOWS A SIGN OF BREAKING OR CRACKING OR IF EITHER BUCKLE FAILS TO OPERATE PROPERLY, OWNERS SHOULD PROMPTLY CONTACT THEIR AUTHORIZED DEALER TO SCHEDULE AN APPOINTMENT TO HAVE THE BUCKLE REPLACED OR REPAIRED, FREE OF CHARGE. THE MANUFACTURER IS DEVELOPING A REMEDY DESIGNED TO PREVENT FAILURE OF THE BUTTONS THAT ARE NOT CURRENTLY BROKEN.
Notes	SYSTEM: INTERIOR; SEAT BELTS; BELT BUCKLES.VEHICLE DESCRIPTION: PASSENGER VEHICLES AND LIGHT DUTY TRUCKS AND VANS EQUIPPED WITH SAFETY BELTS MADE BY TAKATA CORPORATION.NOTE: IF YOUR VEHICLE IS PRESENTED TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND THE REMEDY IS NOT PROVIDED FREE OF CHARGE WITHIN A REASONABLE TIME, PLEASE CONTACT MITSUBISHI AT 1-800-222-0037. ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S AUTO SAFETY HOTLINE AT 1-800-424-9393.

Component	ELECTRICAL SYSTEM:WIRING
Manufacturer	DIAMOND-STAR MOTORS
Mfr Report Date	19880901
NHTSA Campaign ID	89V128000
Summary	WIRING HARNESS FOR THE HEADLAMPS MAY BREAK DUE TO THE STRESS CREATED BY THE HEADLAMP POP UP DEVICES.
Consequence	BREAKAGE OF THE WIRING HARNESS CAUSES LOSS OFHEADLAMP ILLUMINATION WHICH COULD HAVE A POTENTIAL FOR AN ACCIDENT.
Remedy	HEADLAMP WIRING HARNESS ROUTING WILL BE MODIFIED AND DAMAGED WIRES REPAIRED.
Notes	SYSTEM:ELECTRICAL, UNDERHOOD WIRING HARNESS.VEHICLE DESCRIPTION:PASSENGER CARS.

Component	POWER TRAIN:AUTOMATIC TRANSMISSION
Manufacturer	MITSUBISHI AMERICA
Mfr Report Date	19890515
NHTSA Campaign ID	98V069001
Summary	VEHICLE DESCRIPTION: PASSENGER VEHICLES. LOCKUP OF THE TRANSFER CASE CAN OCCUR DUE TO INSUFFICIENT LUBRICATION.
Consequence	THIS CONDITION CAN CAUSE A LOSS OF VEHICLE CONTROL, INCREASING THE RISK OF A CRASH.
Remedy	DEALERS WILL INSPECT THE VEHICLES FOR ADEQUACY OF THE TRANSFER CASE OIL VOLUME, TRANSFER CASE OIL LEAKAGE, AND OPERATIONAL DEGRADATION OF THE TRANSFER CASE MECHANISM. IF OIL VOLUME IS INSUFFICIENT, THE APPROPRIATE AMOUNT OF OIL WILL BE ADDED. IF THERE IS TRANSFER CASE OIL LEAKAGE, AFFECTED COMPONENTS WILL BE REPLACED. IF THE TRANSFER CASE SHOWS OPERATIONAL DEGRADATION, THE TRANSFER CASE WILL BE REPLACED.
Notes	OWNER NOTIFICATION IS EXPECTED TO BEGIN APRIL 20, 1998.OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT MITSUBISHI AT 1-800-222-0037.ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S AUTO SAFETY HOTLINE AT 1-888-DASH-2-DOT (1-888-327-4236).

Component	VISIBILITY:SUN/MOON ROOF ASSEMBLY
Manufacturer	MITSUBISHI AMERICA
Mfr Report Date	19890601
NHTSA Campaign ID	90V056002
Summary	OPERATION OF SUNROOF IN 'NON-STANDARD' MANNER MAY CAUSE MALE HINGE DISENGAGEMENT FROM THE ROOF HINGE RECEIVER.
Consequence	THE SUNROOF GLASS COULD DETACH FROM THE ROOF AND RESULT IN INJURY TO OCCUPANTS OR PERSONS IN THE VICINITY, ESPECIALLY IF THIS OCCURS WHILE THE VEHICLE IS IN MOTION.
Remedy	REPLACE MALE HINGE WITH A MODIFIED VERSION TO INCREASE ROOF HINGE RECEIVER RETENTION ABILITY.
Notes	NOTE: THIS RECALL APPLIES ONLY TO DIAMOND STAR MOTORS INSTALLED SUNROOFS.CHRYSLER CORPORATION'S PLYMOUTH AND EAGLE DEALERSHIPS AND MITSUBISHI MOTOR SALES OF AMERICA WILL IMPLEMENT THE RECALL ACTION.SYSTEM: SUNROOF HINGES.VEHICLE DESCRIPTION: PASSENGER CARS EQUIPPED WITH DSM MANUFACTURED SUNROOFS.

Component	VISIBILITY:WINDSHIELD
Manufacturer	MITSUBISHI AMERICA
Mfr Report Date	19900501
NHTSA Campaign ID	90V106002
Summary	DILUTED PRIMER MAY HAVE BEEN USED ON THE WINDSHIELD OPENING FLANGES PRIOR TO WINDSHIELD GLASS INSTALLATION WHICH WOULD NOT PROVIDE THE RETENTION REQUIRED BY FMVSS 212.
Consequence	WINDSHIELDS WOULD NOT PREVENT EJECTION OF VEHICLEOCCUPANTS DURING A VEHICLE CRASH, WHICH CAUSES SERIOUS INJURIES AND FATALITIES.
Remedy	REPLACE WINDSHIELDS, ASSOCIATED PARTS, AND PRIMER.
Notes	SYSTE: WINDSHIELD MOUNTING; FMVSS 212.VEHICLE DESCRIPTION: PASSENGER CARS.

Information provided by NHTSA
Data updated June 2024

1990 Averages

Avg. Car Cost :	$16,000
Avg. Household Income :	$28,970
Avg. Home :	$123,000
Avg. Gallon of Gas :	$1.12
Total Car Production :	9,782,997

1990 Mitsubishi Eclipse FAQs (show)

Popular frequently asked questions include:

What are the dimension and mechanical specifications of the 1990 Mitsubishi Eclipse?
How many 1990 Mitsubishi Eclipse were produced?
How powerful was the 1990 Mitsubishi Eclipse? Was the 1990 Mitsubishi Eclipse popular? Was the 1990 Mitsubishi Eclipse expensive? What was the fuel economy of the 1990 Mitsubishi Eclipse?

Q: What is the wheelbase size of the 1990 Mitsubishi Eclipse? A: The 1990 Mitsubishi Eclipse has a wheelbase size of 97.20 inches.

Q: What is the length of the 1990 Mitsubishi Eclipse? A: The 1990 Mitsubishi Eclipse has a length of 172.80 inches.

Q: What is the width of the 1990 Mitsubishi Eclipse? A: The 1990 Mitsubishi Eclipse has a width of 66.70 inches.

Q: What is the bodystyle of the 1990 Mitsubishi Eclipse? A: The 1990 Mitsubishi Eclipse was a .

Q: How many vehicles did Mitsubishi produce in 1990? A: Mitsubishi produced 99,630 automobiles in 1990.

Q: What engine did the 1990 Mitsubishi Eclipse have? A: The engine powering the 1990 Mitsubishi Eclipse was a Inline 4 (1775 cc | 108.3 cu in. | 1.8 L.) with 92 BHP (67.712 KW) @ 5500 RPM and 105 Ft-Lbs (142 NM) @ 3500 RPM.

Q: What transmissions did the 1990 Mitsubishi Eclipse have? A: The 1990 Mitsubishi Eclipse had the following gearbox options: 5 speed Manual, 4 speed Automatic.